Middle gear nut

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

davidon

Well-Known Member
Joined
Apr 6, 2006
Messages
1,576
Reaction score
6
Location
Gaithersburg, MD
Getting ready to attempt to remove/replace the middle gear nut while everything is in the bike. Need advice on best way to do this. Put bike in gear, not in gear, etc.
 
Impossible to do (if removing the middle gear itself). You can't compress the spring to release the "C" clips. Transmission shaft needs to be out of the engine case. If you are talking about the big nut under the middle gear cover then that can be done but not sure why you would do that?

If you are talking about the nut holding on the ujoint that's a different story.

Sean
 
You should be able to put it in gear but make sure you don't rotate the bike off the sidestand ni case you manage to turn over the engine before it comes loose. That's a huge nut - where'd you get it? Picture?

Sean
 
Back
Top