davesax36
Well-Known Member
Ok, guys. I've got the bike reassembled enough to start testing for my electrical gremlin. I get stronk crank and no spark. I've got a test kit from Sean and have replaced my parts with his at the following locations
bar switch housings
left side cover relays and boxes
tci brain
ignition switch (key)
sidestand switch
With these items plugged in, I still get strong crank and no spark. I'm getting ready to move on to coil replacement, I just have a hard time believing that all the coils went bad at the same time. Not that I've heard this bike run at all yet. I've only gotten one backfire with starter fluid and I don't want to try that again. I'm taking suggestions and I'm on spring break, so I can actually do some stuff right away.
Here's a pic of the reading I get from my pickup coil. I'm sort of bad at using the multimeter, I think, because I rolled the ohm load adjuster wheel full on and off and it changed the reading. However, when it was reading steady, I took this picture. Thanks for all your help.
bar switch housings
left side cover relays and boxes
tci brain
ignition switch (key)
sidestand switch
With these items plugged in, I still get strong crank and no spark. I'm getting ready to move on to coil replacement, I just have a hard time believing that all the coils went bad at the same time. Not that I've heard this bike run at all yet. I've only gotten one backfire with starter fluid and I don't want to try that again. I'm taking suggestions and I'm on spring break, so I can actually do some stuff right away.
Here's a pic of the reading I get from my pickup coil. I'm sort of bad at using the multimeter, I think, because I rolled the ohm load adjuster wheel full on and off and it changed the reading. However, when it was reading steady, I took this picture. Thanks for all your help.