I would love to get this as well, I am currently stuck in the middle of a progressive spring installation (very stuck).
On page 9 of the service manual (37 in the PDF) it states....
The following is listed:
4. Remove:
Bolt (damper rod)
Copper washer
NOTE:
Loosen the bolt (damper rod) while holding
the damper rodwith theT-handle and holder.
Holder (29 mm):
90890-01326
YM-33962
90890-01375
5.Remove:
Inner fork tube
How do you "lossen the bolt" I looked into the bottom of the fork and looks like there is a square drive recepticle? The manual states you need a T-handle, does everyone use one?