Recent content by bradnw

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. B

    Don't blast me

    For all practical purposes I am at sea level. I am on the list for the "traveling shim kit". Maybe the valves are not quite right.... I am 6'5 225 Thanks Brad
  2. B

    Don't blast me

    Everything is working. I guess the "kick in the gut" is different for each person.. The vboost opens fully above 6k I guess my expectations were a little high I am on the valkyrieforum.com forum as well. Do tell about the carb spring mod? Thanks Brad
  3. B

    Don't blast me

    The solenoid, and the Controller were replaced as part of the restore.... The valves open and close as port of the initial power on, I will check at 6k to see if they open properly this afternoon, did not want to wake the neighborhood at 6 am.
  4. B

    Don't blast me

    I will test the rpm /open tomorrow in the garage It does open and close at power on Not completely road ready ( tires , turn signals lots of clean up Thanks
  5. B

    Don't blast me

    Will it open in neutral? At 6k
  6. B

    Don't blast me

    Brand new NGK plugs Carbs synced and vboost valve adjusted per fsm Thanks
  7. B

    Don't blast me

    I have a Valiyrie, 3rdGen Magna and recently acquired a 2006 VMax with less than 12 k on the odo. After much work any many questions ( thanks Sean) and lots of parts lol it is finally running great. I took it for a short test ride and v-boost at 6k and up was disappointing. Please make any...
  8. B

    Strange Problem

    I have done a little work on the bike I have acquired recently, now after reassembling, I have a small issue. I can start the bike, for a few seconds, it revs up to about 4k then dies out . I can hear the fuel pump click on, for a few seconds, the the fuel pump relay seems to be working. Is...
  9. B

    Starter issue

    The starter button is disassembled and it still happens. There is 12 V at the solenoid as soon as the key is turned on and the the run switch is turned on Thanks Brad
  10. B

    Starter issue

    Not sure what's going on, but as soon as I turn on the key and flip the run switch to on the starter engages and stays engaged. I have disconnected the solenoid trigger wires starter does not spin. Removed the starter button still spins. Any advice would be greatly appreciated Thanks in...
Back
Top