Quantcast

Latest activity

Yamaha Star V-Max VMAX Motorcycle Discussion Forum

Help Support VMAX Forum:

  • Parminio
    Parminio reacted to one2dmax's post in the thread Gen2 ceramic bearings with Like Like.
    They provide a much lower rolling resistance due to thinner or even no lubrication/grease being needed. The difference can be pretty...
  • CaptainKyle
    CaptainKyle reacted to 82ndCowboy's post in the thread I'm Baaaa AAack! with Like Like.
    OK guys. I have left facebook. They are EXCOMUNICADO! I have removed them from my phone and will no longer be participating in their...
  • Fire-medic
    Fire-medic replied to the thread OMG Help!.
    Yes, that's why I posted the screenshot from the VMX12 factory manual.
  • CaptainKyle
    Cleaned up the tail area today thanks to Sean! Still some tweaking to do just ran out of time. Thanks a bunch Sean!!! Before and After...
  • CaptainKyle
    CaptainKyle reacted to 82ndCowboy's post in the thread OMG Help! with Haha Haha.
    I'm sitting here in my clean garage drinking a frosty and I just noticed my #2 cylinder has got pushed over an inch. And its pushed...
  • CaptainKyle
    CaptainKyle reacted to Fire-medic's post in the thread OMG Help! with Like Like.
    Not clear on what you're complaining-of? Can you use a drawing program to show us what you mean (like the arrow)? Methinks you're...
  • CaptainKyle
    CaptainKyle reacted to one2dmax's post in the thread OMG Help! with Like Like.
    I believe he is just joking with you guys. BUT as the screenshots of the manual show above there is an offset in cylinders (which is...
  • Fire-medic
    The one w/the R1 tailsection and the braced swingarm looks like it has good potential. Braking looks better, too.
  • Fire-medic
    Fire-medic replied to the thread drive shaft leak.
    Thank-you, once-again, for your free dispensing of VMax knowledge.
  • Fire-medic
    Fire-medic replied to the thread Yamaha part numbers?.
    If I'm ordering parts, I usually check several of the online retailers for pricing. I've used partzilla before but I usually use Ron...
  • one2dmax
    one2dmax replied to the thread drive shaft leak.
    It is a normal thread direction but there is just not much room in there. I haven't tried the gear wrench though. Yes, I have done it in...
  • one2dmax
    You need to buy one (or both) of the project bikes! Cheap (relatively lol). Quite a bit of work on them already but plenty to go.
    • IMG_20200411_140436.jpg
    • IMG_20200411_141503.jpg
  • one2dmax
    one2dmax replied to the thread Yamaha part numbers?.
    The fiche is usually available on the Yamaha website. Look up 2007 for the most current part numbers which will work for 90+ percent of...
  • one2dmax
    You cannot get one from Yamaha as a general consumer. It was many many phone calls for me to get one for a Warranty replacement and the...
    • Gen 2 Crate 1.jpg
    • Gen 2 Crate 2.jpg
    • Gen 2 Crate Engine Part Number.jpg
  • one2dmax
    I did 210 miles today with my laptop in my backpack so I could stop and tune along the way. Still got a couple of rough spots to work...
Top