Cool my friend thank you, I had a family emergency so my boy has been messing with it. And I wasn’t sure either even though I took it apart lol. Ole boy had the nerve to ask me why I didn’t pay attention lmao.
Thank you buddy 1 more question I am coaching my boy Via the phone lol. Does that oil seal get pressed to the Mech seal? Because that gap is far wider then the oil seal
The Sadness is incredibly painful, it’s strange the only thing in life that is absolute and always has been absolute is the hardest thing to deal with. My wife lost her grandmother 2 months ago. She was 97 years old and boy did that Woman have a good run. I’m sorry for your loss head up this...
I’m not in front of the housing but the picture my boy sent me that is No Tool Mark, or wear, I’m not sure of the process they use of casting the housing but it would be interesting to find out. Was it a defect in the mold or was the molting metal off
Any idea at All what the Hell this micro Spring could of went to? It was stuffed inside the Oil seal, you know how it’s got that inside race if you will. Well this thing was inside. Does that seal seat open end against bearings?
it is interesting it’s almost like its real porous like pot metal. That picture is a bit distorted after coming into my phone and resending. I feel like I should either get another pump rebuild kit from you when I come through town or just Halt everything and chase down a new pump housing. I...
So Sean mailed all the parts to rebuild my Gen1 water pump. I haven’t been able to build it yet completely do to Family matters. But this picture I’m providing is the Ring that the oil seal seats inside of. This is a defective housing, thats No tool mark and can’t be from bearings over heating...
I drilled out Beveled and tack welded The Round into the high peg/motor guard. That’s just a small amount of bondo I think it should hold up fairly well