Search results

The disk's were glazed pretty badly, and the calipers were full of brake dust. I cleaned the rotors then hit them with some 2000 grit and cleaned them again, and I cleaned out the calipers. It has mostly gone away but I can still feel it a tiny tiny bit so I feel theres probably some disk...

I was thinking a warped rotor too. can I check that with a straight edge? or how would you go about checking that? The wheel weight was still on in the correct spot. I think im gonna give the sanding and a good cleaning a try. Thanks.

I have a 1990 Yamaha Vmax and it used to not do this but recently, the front wheel as started like bouncing almost when I brake and the slower I get the slower the bounce gets. Also if I brake and it bounces and if I let off and then brake again it stops doing it for a little bit then starts...

Ya that was my bike. I haven't measured the diameter of the pipe, but its the 4 into 1 kerker. I have the muffler, I just didn't have it on in the video cause I was prepping it for paint.

It just blows my mind with power... its got more ponies than my first car!

How much would a dyno cost? and do you recommend any place in the Tulsa area for that?

I got it up to 9 grand today, it is a total beast! I could feel the rear wheel break loose goin' through the gears! I think i'm going to like this bike!

This is my first vmax, and ive never seen or heard a vmax in person before... I bought it with electrical problems and fixed it so now it runs. I know it has full kerker 4 into 1 exhaust, buts all I saw that has been done to it. Does this sound like a stock motor or has it been modified? It...

Thanks! I got it figured out now

I recentyl purchased a 1990 Vmax. The previous owner installed a toggle switch which he said was the vboost 3k/off/6k switch its a 3 position switch. However, its just dangling there and I want to mount up on the handle bars and make it look nice and label the switch positions but I cant figure...

I have a 1990 V-max 1200cc as I was changing out the oil filter, it wasnt on right and I broke off one of the 2 little ears.... It snapped off and took a about of 1/4 inch of the outter gasket surface with it... I just kinda sat the peice back on and bolted it all together and started it...