spottedsquirl
Well-Known Member
Hi everyone! I have an issue that started through the winter. First had a leak at the drain valve. I now have a new OEM tube installed. Now there is a leak where the tube goes into the engine block. I replaced the old o ring with a new one. The new o ring is a bit fatter than the old but didn't have any issues with installation. However it is still leaking. I did try disassembly and reassemble. Although, it is not leaking as bad now, there is still a slow drip. There was another thinner o ring I could have got but, it didn't seem like it would seal around the tube, slightly loose fit. Is it supposed to seal around the tube or seal as it sandwiches between flanges?
Sent from the open road using Vmax
Sent from the open road using Vmax