DirtieGirtie

Sooooo... I rode to work and home yesterday. No slipping at all. Thank you so for continuing to push me on the hydraulics side of the...

Rain today prevented me from the trial run. Instead, I took the clutch master cylinder off my other Vmax, the yellow one... Never had an...

I just read deeper into the archives... https://www.vmaxforum.net/threads/clutch-return-hole.53455/ I would post a link to two other...

I rebuilt the master cylinder. I filled the system using the reverse flush method. Then I replaced the slave cylinder with a brand new...

Well, I replaced the clutch. Same problem. When I first get on the bike the clutch seems to grab decent. But once it heats up, clutch go...

New slave cylinder is in. Still slips under hard acceleration. It is better, but still slips. I'm wondering if the previous owner put...

Thanks, guys. I've rebuilt slave cylinders before, it just confuses me that the hydraulic system is the issue. Piecing together the...

I know I'm third in line, but PM has been sent.

EXPERT HELP REQUESTED! She's all back together, but I have a problem with the clutch. Here is what I am experiencing: 1. Start bike 2...

The carbs I just rebuilt had the entire bore for the air mix screw smothered in Silicone. I could imagine why the PO would do discuss a...

Pics or it didn't happen.

I'm not certain because of the angle of the pics, but I think those are too rich, not too lean.

What FM said. I bought this set for $17 off Amazon. "Neiko 10076A 3/8-Inch Drive Extra Long Allen Hex Bit Socket Set, Metric, 3 mm - 10...

And after putting the carbs back on and finally putting a bit of new gas in her, she fired right up!!! The pull side throttle cable...

I... FINALLY... finished the carbs. Here's a before and after of the carb bank. Hopefully you can see the tiny difference in cleanliness.