Recent content by Down Under Thunder

Thanks for that! Seen guy that done the carbs and is going to look at them again,something not adjusted right. Have a good one!

Have not had anything to do with Vmax carbs before Had the bike sitting around for some time,cleaned out tank, fuel lines,new filter and had carbs fully cleaned and checked out.All 4 slides are free of any gum,all move freely by hand. Syncronizing the carbs is not happening as planned.On idle...

Got it out ok without breaking it.The breather is an OEM replacement listed.I have already purchased the billet cap from Tom at PythonMotorSports, they look great.I think i will go with your idea Fred of the stainless tubing because that alloy top cap is flimsy spot weld. The swingarm was only...

Thanks guys! Sent the swingarm out to get repainted and somehow they broke the plastic top off. I`ll see how i go with it.

Is the Gen1 Vmax final drive breather a screw in or push in type?

Go to YamahaSportsPlaza.com Their pricing is good.Just purchased rubber joints and clamps for my `96 from them. Joints were US$14.23 each and the clamps US$2.57 each for a total of US$77.48 plus shipping. The clamps can be reused but if it has been sitting around in the weather i`d go for new...

Hi! Safest and surest way to remove "sticky"from old weights is to pull the bulky pieces off with fingers then soak a soft rag with kerosine, dab the rag onto the gum as to saturate the gum and then rub away. Kerosine contains a lot of oil so it will not harm the paint. When finished, dry area...