gentsvmax's latest activity

Ever go to Winchester Speedway? Winchester Speedway :: The Action Track I know Muncie is just west of it. Here is a picture of my...

No, you did what we need to do, cull-out the incorrect info. I didn't just make a 'scrivener's error,' dropping a zero. I sold last...

Why do you want to run C.O.P.s?

These arent built like an old Power Glide etc. There are no front or rear pumps for the tranny, no lube magic mystery going in there...

I used one of those at a fraction of the OE cost pumps till it failed long after my planned return of the oe pump. Infact it lasted so...

Try swapping the ignition coil for the bad cyl to another location and see if the miss follows the change. The right front is the #4...

At minimum I would split the rack, get the #4 carb off and apart for a soak in the carb cleaner. The Ultra-bath is best, ultrasonic with...

Look at your amazon choice, country of origin

Yea, there are a few hidden value item's out there. in lighting are some good examples. Daymaker, for example, about 250 for my version...

This site has some real die hard want to help helpers, 5 replies with earnest suggestions to an obviously none mechanically inclined can...

Make sure that your meters are correct by switching lines when the engine is running to see if the correct pressures transfer to the...

These carbs require a very thorough, complete disassembly and cleaning. I mean a carb clean soak minimum, ultrasonic bath being the best...

I have always broke them in pretty hard ! I figure after the Dyno time it should be pretty good. I have not been giving it a whole lot...

I have already put a couple hundred miles on it and running it somewhat hard. I figure if it held up on the dyno it's good to go.lol

Hey TooOld, whew! finally got those dims. 18.5" both sides, hyme joint eye center to center.