Recent content by kjerkegaard

UPDATE: Have now tested the rectifier, Connected to the stator and measured the output voltage from the +\- cable plug from the rectifier. Output voltage measured is below 1.00. Do People agree that it must be the rectifier?

Hi a while ago, after a short stop buying fuel, i suddenly couldnt start the bike. The starter couldnt crank the engine. I ran the bike to start and when i Got back i figured out that my battery was dead i charged the battery and could now start the bike again without problem. I have tested the...

Hi i never replied on this with a solution. bought new pilot jets - original, and gave the carburetors a good Air blow through all holes and also used some carb cleaner. Also bought original Air/fuel mixture screws. Seems to run much better now. Thanks.

Ensure you have sufficient slack in your cables. Change your gas filter, they're cheap, especially if you use a properly-sized aftermarket one. just changed. OEM Drain each of your float bowls into a clear container, one at a time, emptying it in-between. Don't do it within distance of any...

I did it last season. Although The thought of syncing the carbs did catch me today so im gonna go do that one of the next days.

Hi im having trouble with my vmax 97. the bike seems to run great In overall but it is hesitating when turning the throttle from idle position. I have cleaned the carburetors. The hesitation was there last season so i thought that a good cleaning of carbs would do it. im running stock jetting...

Okay. So 7/64 “ is OEM specs?

Does anybody In here sell the OEM slides cheaper Than the generel internet sides?

Spring 11,8 mm so around 7”.

Aftermarket is around 2,2 mm OEM drilled is around 4,1 mm

Gonna take a look when i come back

I actually dont know the size of the holes of the aftermarket slides. Is it only the size of that hole which defines how Quick the slides operates. And does anybody know the size of hole on the OEM slides? I believe i could try to put In some epoxy and redrill it. Now im also wondering if it is...

No not anymore. Sadly it is the OEM slides he drilled out

Hi Is it a Big problem running with slide diaphragms where the previous owner has drilled out the holes for DJ S7 kit on a stock set up. ? I have some aftermarket slides, but they of course act different from the drilled OEM slides, and im wondering how they actually should act? Thanks Soren

Thanks for the tip. Works very Well.