VMAX  Forum

Help Support VMAX Forum:

MaxMidnight
Reaction score
747

Latest activity Postings Media Albums About

    • MaxMidnight
      Have attached the dimensions of the spindle and spacers + the fitting sequence. You will also want to know how to fit the Dust cover...
      • Diversion spindle and spacers.jpg
      • Diversion spindle spacers.jpg
    • MaxMidnight
      Agree with Mr Medic - if the rubbers were air to be drawn in then that would result in a lean condition. A starter fluid test described...
    • MaxMidnight
      Check the basics like plugs air and fuel filter, tank vent isn't restricted etc. Check that there are no error codes. Swap back to OE...
    • MaxMidnight
      MaxMidnight replied to the thread hesitation and backfiring.
      Before changing anything other than service items make sure the part you are planning to replace is faulty. If you haven't done a full...
    • MaxMidnight
      MaxMidnight replied to the thread Battery.
      I've had Odyssy AGM's in the past and they gave good service provided they were maintained correctly.
    • MaxMidnight
      MaxMidnight replied to the thread Carb synch.
      I wouldn't worry about that if 1 & 2 change they keep the same value relative to each other. Can you synch 3 to 4? If you can you then...
    • MaxMidnight
      MaxMidnight replied to the thread Battery.
      It would be helpful to know which batteries and price points you have had previously.
    • MaxMidnight
      MaxMidnight replied to the thread Carb synch.
      Process is: Synch #1 carb to #2 (screw on LH side) Synch #3 to #4 using the rear screw on the RH side Synch #1 & 2 to #3 & 4 using the...
    • MaxMidnight
      MaxMidnight replied to the thread carb overflow tubes.
      Don't think so Danny but we may be talking at cross purposes here. My understanding is that the overflow tubes are the ones that fit...
    • MaxMidnight
      MaxMidnight replied to the thread VIN number help.
      JYA1GR005FA000210 JYA J = Japan Y = Yamaha A = Motorcycle Class 1a GR005 - Vehicle attributes - 1985 US market either Dark Amethyst...
    • MaxMidnight
      MaxMidnight replied to the thread carb overflow tubes.
      Do you mean the float chamber overflow tubes i.e. those that allow excess fuel to drain due to (say) a float needle valve sticking open...
    • MaxMidnight
      If memory serves well (or not) I had the same issue. As far as I can recall there isn't a captive nut but it is threaded into the frame...
    • MaxMidnight
      Undo the drain bolt (#21 ) on the side cove and drain the Middle Gear oil which can be collected and re-used. You may loose a little...
      • Crankcase Covers.jpg
    • MaxMidnight
      MaxMidnight replied to the thread Carburetor.
      Sorry if I'm being thick but is that yes to OE needles, PAJ's and V Boost?
    • MaxMidnight
      MaxMidnight replied to the thread Difficulty shifting.
      Is it difficult to change gear i.e. high lever effort required or the clunking as the gears engage that bother you? If the latter then I...
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top