Recent content by millera1963

thanks everyone for the help i found a leak in the right front carb rubber boot that gave a low vac reading i'm all snyced up thank everyone

i just won't to thank everyone for there help i found a leak in the rubber boot from the carb to the motor that was the low vac problem now i'm all synced up thanks every one

ok i'll do that tomm. thank you

the front right is the only one that the vac will not move when i turn any of the adjustment screws when i adjust ether screw on the right side the vac on the back right goes up and down the front right stay the same

ok i'll do that the two adjustment screws on the right side should not adjust the same carb or should it?

do you think a intake leak can make the vac on that carb low

yes on the slides not sure about firing going to check comp. and firing tomm. can a intake leak make the vac on that carb low

(motion pro) i changed the lines and got the same low vac

i did it like that but the vac on the front right hand carb will not move?

i have low vac on #1 carb snyc the left side got to the right side and #1 carb has low vac i have turned both adjustment screws on the right side and the back carb on the right side vac moves i need help[ its a2003 i got in feb 2012 so im new

i have a 2003 i was going to sync the carbs the two on the left went good the #1 on the right has low vac there are two adjustment screws when i turn the one on the front riht hand side the back right hand carb adjust the same thing happens when i adjust the back screw on the right side the #1...