Recent content by natnic

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. N

    slow speed steering turn in

    Had a Dunlop that did that put metslers on,it was a differant bike after that.
  2. N

    Roughing up the rotors

    If the grooves are deep the pads will sit on the peeks and can be damaged by overheating in those areas if used hard,and they will need a lot longer to bed in.
  3. N

    New Member!!

    Welcome to the forum 97 silver Sydney
  4. N

    Too hot to handle

    + Run without cap if it still bubbles after warm up get a co2 block check from a garage to test the h gaskit.
  5. N

    Sydney Australia Rides/Meets

    Taking the max on a Friday night ride with southern cross cruisers Mc Donalds orange grove Rd Liverpool 7 pm depart.
  6. N

    Sydney Australia Rides/Meets

    Im up for a ride, Sutherland 97 silver
  7. N

    Any Vmaxers in Sydney NSW

    Hi sutherland 97 silver black
  8. N

    1988 VMAX Rear Suspension Question.

    Hi the pre load is adjusted at the bottom of the shock by turning the cam.Sutherland nsw 98 max.
  9. N

    Problems with my new Max

    That's good the ones off the shelf arn't that good, it's got to be trade.
  10. N

    Problems with my new Max

    Hi as my last post try the nulon im a mechanic and wasn't confiedent that it would fix the spitting back through the carbs .But no time to pull them apart so I gave it ago ran real bad for about tree kays then cleared up and now runs and idles great .Its a 97 30k with plugs still in the...
  11. N

    kinda bored with Vmax already

    Try turning the key
  12. N

    Problems with my new Max

    Hi get some Nulon fuel system cleaner not the regular type but the trade use only in a can
Back
Top