Recent content by NHMax

M4x.8 ? "Standard m4 thread is .7"

I left the drain screws in the fork tubes when sending them for powder coating. Anyone know the thread pitch so I can source/make new ones

Got the lower fork tubes back from Powder coater FINALLY Next time I am going thru a Shop directly, not a buddy thru his buddies shop took a month and they F'ed up the cross over support they didn't know it was magnesium and acid dipped it I guess it dissolved HAHAHAHA they got a replacement...

Probably not New springs are .95KG

Finally got the call my Lower legs and fork Brace are done at powder coater ALL new seals and wipers, Race tech springs, cartridge emulators question is Should I eliminate the air crossover tube? I think a oring is missing I have to take a closer look, tube after years is bent up pretty good Can...

150,000 second owner BFF was the first and he went 115,000 of them

I split the calipers Lightly clamped .055 thick Machinist scales over the transfer ports Air hose, with thick cardboard on top of bench they shot right out Id chucking three jaw chuck on a hand lathe with scotch bright pistons OD's look like new I usually use a microscope and a 125 wide and a...

SO my 1985 needs TWO seal kits one for each caliper Two seals and two dust seals in part number 1FK-W0047-00-00

Pulled my front calipers apart Pistons were stuck good I am confused seal kit it $80 Is that per side so I need two or per piston so I need 4?

May have to bite the bullet and pull the carbs to clean them I couldn't get mine right so I sent them for COMPLETE rebuild thing freaking purrs like a kitten again Brand new Exhaust But can't ride it yet cause front fprk seals blew and dumped oil all over the mostly seized front calipers...

So Cartridge emulators are a go also So it will be apart for another week or so drat I was thinking the Gen 1 Hayabusa brake upgrade cause I have three good rotors and a set of calipers around........

Ordering replacement springs thru race tech tomorrow ...unless there is a reason to go with a different brand?

they go into some version of the Chevy LS motor I just make them for the customer Just cool when sometimes I can see my finished products Speedometer center pins AR15 barrel extetions Muzzle loader ram rods/powder measures ect

Damn she starts And idles well Gotta fix brakes so I don’t kill myself

Snapped the 90degree elbow off the coolant overflow bottle Seems the broken end comes right out. Can I just use a air tight elbow?