VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Pighuntingpuppy

Latest activity Postings About

    • Pighuntingpuppy
      Pighuntingpuppy replied to the thread Vmax shuts down.
      I presume no Check Engine Light either. I would pull any codes that might be stored. Give you a starting point. When the bike runs...
    • Pighuntingpuppy
      Pighuntingpuppy replied to the thread Vmax shuts down.
      Does it restart? Does the bike have fuel? Is the kickstand dropping slightly due to a weak spring?
    • Pighuntingpuppy
      By county, yes, New York is red. But cities like Buffalo, Rochester, Syracuse, Albany and the NYMA make up the majority of the...
    • Pighuntingpuppy
      Pighuntingpuppy replied to the thread Fork Seals.
      If you try the business card trick, you just might have some dirt in there and you can save some time and money. My Gen 2 gave me a...
    • Pighuntingpuppy
      Pighuntingpuppy replied to the thread Throttle lock clone.
      I have stock grips on my bikes. The Gen 2 fit very well with the stock grips. NOW.....I have to say....when I bought my Brake Aways, I...
    • Pighuntingpuppy
      Pighuntingpuppy replied to the thread Throttle lock clone.
      I have the Brake Away throttle locks on both my Gen 1 and Gen 2. Both work well. Takes about 40-45 minutes to install and set up. I have...
    • Pighuntingpuppy
      Everyone's opinions are different due to the experiences they have had. My experiences with Shinkos are bad therefore I will never speak...
    • Pighuntingpuppy
      Pighuntingpuppy replied to the thread ABS flashing.....
      Yes. The OEM is LED. What I think is happening is the ground. There is only 1 ground for the brake/tail/turns. That could be causing a...
    • Pighuntingpuppy
      Pighuntingpuppy replied to the thread ABS flashing.....
      When I did mine....the main brake light/running lights had their own OEM style connector. There were 2 individual wires that were for...
    • Pighuntingpuppy
      Pighuntingpuppy replied to the thread ABS flashing.....
      I believe the resistor is wired into the brake circuit. On my bike, the brake circuit was just one wire not two. The two wires were for...
    • Pighuntingpuppy
      Pighuntingpuppy replied to the thread ABS flashing.....
      The code is for an incorrect input from one of the brake light switches. Some have stated that a resistor has helped. Others said it...
    • Pighuntingpuppy
      My bike spends about 80% of the time on the interstates in my state. Thats also why I am over 50,000 miles on my bike. I am 40 miles...
    • Pighuntingpuppy
      Let me clarify that the problem is with the front tire, not the rear. I had 2 back to back front tires have very dangerous wobbles. The...
    • Pighuntingpuppy
      Pighuntingpuppy replied to the thread 30” inseam, lowering.
      Morleys Seat for the Gen 2 lowers the ride height an inch or so. I am 6ft tall. I can feel the pinch up in my knees when riding due to...
    • Pighuntingpuppy
      I dont think no one has gone through as many tires on the Gen 2 as I have. Granted, I have a stock tire on the back of mine. I have...
  • Loading…
  • Loading…
Back
Top