cmw2212
Well-Known Member
I have access to some manometers at work. My question is can I use four individual manometers to do a cab sync and get it real close? We have single manometers at work to check gas pressure on furnaces.
Help Support VMAX Forum:
davesax36
Well-Known Member
I'm pretty sure you can make it work. If you can get the tubes restricted enough to keep the needles even, you'll be fine.
Don't see why not....the Carbtune is basically 4 separate gauges....in the same box.
As Dave said, you'll need to restrict the hole size in the hose to keep the needles fairly steady.....place the restrictions about 4" in from the carb end.
Just had a thought on a possible restrictor......depending on the i.d. of the manometer hose perhaps you could use PFJ's (Pilot Fuel Jets)? The opening is around .010"............:confused2:
As Dave said, you'll need to restrict the hole size in the hose to keep the needles fairly steady.....place the restrictions about 4" in from the carb end.
Just had a thought on a possible restrictor......depending on the i.d. of the manometer hose perhaps you could use PFJ's (Pilot Fuel Jets)? The opening is around .010"............:confused2:
tugla
Well-Known Member
good way to make a guy second guess if all the jets are in the carbs hahahah
but also good way to make it work the sync tool....
but also good way to make it work the sync tool....
:rofl_200::rofl_200::rofl_200:
