Carb sync question

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

cmw2212

Well-Known Member
Joined
Jan 3, 2014
Messages
72
Reaction score
0
Location
Fayetteville
I have access to some manometers at work. My question is can I use four individual manometers to do a cab sync and get it real close? We have single manometers at work to check gas pressure on furnaces.
 
I'm pretty sure you can make it work. If you can get the tubes restricted enough to keep the needles even, you'll be fine.
 
Don't see why not....the Carbtune is basically 4 separate gauges....in the same box.

As Dave said, you'll need to restrict the hole size in the hose to keep the needles fairly steady.....place the restrictions about 4" in from the carb end.

Just had a thought on a possible restrictor......depending on the i.d. of the manometer hose perhaps you could use PFJ's (Pilot Fuel Jets)? The opening is around .010"............:confused2:
 
good way to make a guy second guess if all the jets are in the carbs hahahah
but also good way to make it work the sync tool....
 

Latest posts

Back
Top