gcurtis102

The problem I have had with ethanol fuel is it attracts water and allows it to be in solution with the gasoline. Nothing corrodes an...

I get a tank of stabilized fuel into the bike, then run it long enough to get it through the fuel system and into the carbs. Then at...

Danny is the real deal on this issue in carb rebuilding. He fixed me right up. I highly recommend.

I put an oil pressure gauge on mine just for the peace of mind. Pressure is higher (60 - 70 psi ) on start up and drops to ( 15-20...

I purchased my 88 vmax new in July of 89. put it on a credit card $5000. Still rolling on it.

I have looked for a #3 carb about 3 months now. Very tough to find a single. Many full sets available in quite a spectrum of conditions...

I am looking for a carb body for carb #3. Willing to pay the going rate. Thanks to any that can help.

No big deal if you break the slot, a reverse drill bit will usually pull it out before you can drill through the pilot jet. Harbor...

I use hollow ground gunsmith screwdrivers. You are right to be wary, if you screw it up, any if the carb jets can be tough to get out...

I have pulled apart several sets of carbs on many different bikes. All seem to have stuck bolts. I use a set of vice grip plyers turn...