Search results

Have everything working with the wiring except for 1 thing . The dredded tail light.. It has been swapped by previous owner from the factory tail light to one of the common led 3 wire plug and play lights . ( was never installed but was intended to be .) I have the rear signal lights...

How tight to tighten the Phillips screw in the band around the rubberon the bottom of the carburetor stack? Any info would be great Thanks . GFM

Hey all. I am wondering about the exact placment of the ignition coil stuff and the starter relay and all that "mound " of stuff just above the battery..... ( i am attaching pictures below!) Id like to see how exactly that bracket that everything is mounted on sit in there . Like it looks...

Hey guys. Rebuild is going good. Just have a question . It might be late lol but i am now doing the exhaust system front to back . I am wondering if anyone knows if the front headers are Side specific?. As in they would only fit 1 way better then the other ? Or would it not matter which...

Heu guys just getting rear wheel put back together and im wondering what the torque spec is for the rear brake rotor ?

Can someone tell in detail or show me what these 2 bolts holding the fuel tank look like ?? As well as the orderin which they go on ex.(bolt washer rubber washer) Any lengths sizes bolt head patterns washer sizes anything will help i just working from a big bag of bolts and washers but...

Hey i just got a replacement part for the old fuel line im removing ... ghis one apears to be the same looking on the outside . But it is rubber only . No metal line runs the length of the inside like my old one im taking off . Can anyone tell me why this is ? The old one is in the first...

Any suggestions for grease alternative for where the gear side of the shaft drive meets the gear side of the rear wheel ? It says to used " lithium soap based grease" . Also curious if i should grease the axle that slides through the hub, and any other maintenance that should be done while i...

Hey guys i am at the point in the rebuild where i have got the carb stack and airbox back together . And im redy to hook up the throttle cables . But . It appears that the new after market cable ends that came with the bike must have been larger then stock as the end of the cables dont seem to...

New member from canada 🇨🇦 Hey vmax community, im new to the forum and i have a few questions im trying to answer, also a handful of photo comparison pictures id like to get to see whats what . And heres why i have just got a 2001 vmax 1200 that was basically a motor on a frame + rad ...