loctite
Help Support VMAX Forum:
-
JB weld? Loctite Form-A-Thread? Stripped bellhousing threads
I pulled a few threads from my bell housing the other day installing a cummins into a NV4500 in my E350 fummins. I can (should have) replace the bolt with a longer one and use the 1/2" of remaining good threads which were tested to 30' lbs. But Id like to insure I wont have a problem again...- rebar
- Thread
- bellhousing formathread jb loctite stripped threads weld
- Replies: 7
- Forum: The Pit Stop - Off Topic Forum
-
P
How hot does the engine oil in vmax run?
Hi, I'm wondering how hot the engine oil in vmax runs because i recently stripped a thread for a screw that is holding the oil pump while doing the HD oiler kit. The thread was only half stripped so i applied loctite to it. On loctite's webpage it states that a 5Nm torque gives about 24Nm...- ptnov
- Thread
- engine hot loctite oil run temp temperature thread torque vmax
- Replies: 7
- Forum: General V-Max (1st Gen) Discussions
-
Safe to use Loctite...
in an oil system??? I have an 86 and am putting on the oil filter adapter. Just want to make sure it is ok to loctite it in. Thanks Cheers- RagingMain
- Thread
- loctite safe
- Replies: 5
- Forum: Motor & Exhaust
-
S
Loctite on the carb sync screws
thinking about how we have to sync our bikes up so much. would loctite help us keep dialed in or is it more a valve issue?- serrow
- Thread
- carb loctite screws sync
- Replies: 2
- Forum: Motor & Exhaust