modification

Hi all: I hope you're all staying warm. I have a question for you: My Max is using 1994 Yamaha YZF750 USD forks with a beautiful custom-made triple tree. The triple trees have a 50mm top diameter clamp and a 56mm bottom diameter clamp. Someone has recently given me a set of 1998...

I am in the process of adapting the FZ1 2000-2005 caliper (blue dot) and the 267 rear rotor to my max and I think I have a inexpensive solution. The caliper on the Fz1 is underslung which I like so it would require a post to be welded on the underside of the swing arm. (I had previously welded...

Hey All, I am filling out the form for Sandy to modify the rear wheel on my 2001 VMAX. Please help with the following questions that I need answered to complete the form: 1) Square or round lip? 2) New width? I'm not looking for some huge tire, just an 18". 3) Off center...

Hey All, Another newbie question....... Many of you are saying that on of the best things that can be done for the VMAX is to get some radials on it. Surfing around a bit, I found SKRACING (skracingproducts.com) and Sandy Kosman who modifies the rear wheel to accept a radial. ($595)...

Hi everyone! I hope you're all doing okay. Here's my question: Do any of you know a person or company that can grind an axle's diameter down to a smaller diameter in a safe and precise way? I ask because I'm attempting to mount a 1994 Honda CB1000 front wheel on a pair of USD CBR954 forks...

Hi all. I've just ordered my 4-2-1 UFO system to replace my cobras. But before I send it off to be setup I was wondering how to modify the stock box as I'm now pretty skint. Also what's the most cost effective way to match my fuelling to my exhaust? Thanks guys

I just bought a 97 Max, and I'm loving it! There's only one problem I have with it and that is the mileage I can get on a single tank of fuel. I get about 125 pretty regularly before I have to switch over to reserve (Though I fill up before reserve most often at around 115). This isn't a...

Take a look at my exhaust pictures. http://www.vmaxforum.net/album.php?albumid=426

I've had a few questions on hole size and location so here's a quick pic. The three smaller holes are 3/8". I'm planning to open them up a bit more later. I started small just in case. The one down inside is a 9/16" hole. I'm thinking of opening this one up as well.