Search results

I have a 2002 VMax, and am window shopping front end change, maybe like a R1 tubes and triple trees, what is the best year to use? Or, any suggestions would be appreciated. Thanks, Steve Kent

I seen awhile back someone had custom made tach instrument covers for sale, I am looking for them...thanks

I have a 2002 max, after sitting for a couple of weeks, I went out to shop to start it up, battery low, put trickle charge on it. Went to start it up the next day, everything came on and engine started spinning over....then, everything went off as if battery was jerked loose. Started checking...

looking for some forward controls to fit 2002 Max.

Anyone have a used set of velocity stacks that attach to the diaphragm caps of the 1200? I know I can get them new for around 150, but, money is tight and I just wanted to get a set saving a little. Just thought I'll reach out and see...thanks, Steve Kent

What did I do wrong? I replaced my seals and installed new Progressive springs.......now, I have no give in forks! I used stock spacer, but, I didn't think it needed to be cut down, about 5/8" more above tube at install. added the 4 and 3/4" from top fork oil level, installed the caps, now...

I keep seeing on Ebay exhaust servo motors for sale, I have a 2002 Vmax, I can't find this on my bike! Do all maxs have this? or, just certain years?

I seen an article just a while back where someone done a "washer swap" and installed a wider rear tire, I'm wanting to check into it again, I want a wider rear tire as well as my friend on his bike. Can someone assist me? Thanks, Steve Kent

I'm looking for a set of Kerker or SuperTrapps slip-ons for Gen 1 Vmax. I've been searching, and bidding on Ebay, just can't afford such high prices asked for or going for there. $200 range plus shipping I could afford, hard to get over that. Please, if you can help me, I'd appreciate it much...

I have noticed every time I go for a ride, even short hops of 10 miles or less, I have oil blowing on left side on top of stator case cover. It,s coming from looks like lower cylinder or base gasket. I am assuming this means that I must pull engine and do top end? Shops around here will no...

How hard is it to install a Barnett clutch conversion? I've noticed a bit of slippage in my clutch when I open it up hard, and I want to change out to Barnett pressure plate......now, I've heard some that say they install and can't get clutch to work........some have no problems. I can follow...

Does anyone know if a 170/80-15 will fit without any issues on the rear of 2002 Vmax? Everything is stock with swingarm and so forth. Thanks, Steve

I didn't get the 85 Vmax I was wanting (guy didn't really want to sell it), but, I have purchased an 2002 Vmax. I am wanting a shift light and wanting to locate some Infinity covers...(lighted tunnel appearance instead of clear). I have seen them years ago on a Max, just need some advice where...

I am going to check on a 85 Vmax Thursday, the owner won bike in a raffle, carbs were rebuilt, Barnett clutches installed alone with slave cylinder. Shop drove bike, said they have worked on several in the past, and it runs as should. Question, how to know if boost works? What other things...