ign

I'd like to learn how the ignition switch is wired. I've searched but have not found a pinout diagram. Please post up!

Which setting seem to be the best on 2006 vmax? I have Vgas with ram air scoops. Getting mainly for rev limiter.

I have an older two ign pickup bike. If I put in a newer engine with a single pickup and I have the wire harness and black box will all other electrics plug up to the newer harness? Thanks Jim

Hey guys, I have a 1300 conv by Sean. We have the ported heads, 12:1 pistons with stage 3 cams. Thing already runs like a raped ape, but I miss the advance I had with my Dyna. I dont thrash the bike, just use it as my daily driver. So do you all think it would be safe to put the Dyna back...

I have been having troubles since getting her going after winter, done the cop mod and went to go on a ride and ran like crap poping backfiring the good stuff came back checked cop wiring, it was good checked plugs and they were good (cleaned anyway). So I start with the carbs shotgun 4 times...

I just finished testing the 4 coils I got from Pinwall and 3 coils Morley sent. I also just tested a set of p/u coils from Morley. I'll post the results of everything: My '85 (on the bike) pickup coils: B-O: 119.9 ohms B-W/R: 120.4 ohms B-Gray: 121.6 ohms B-Whi/Green: 120.5 ohms Morley's...