sender

Hello all There is any chance to find a vmax fuel sender with changing resistance ? I need 0 – 90 ohms – and not interested to drill a holes in the tank… the idea is to replace the stock one in the same position and hole I know that’s is long shout…... but still – in this forum...

I think I may have a problem with the reserve on my Gen1: after the light is on either the control switch (at the handlebar) does not work, or the sender assembly on the bottom has a problem. It happened around 10 years ago already, but I can't remember how I resolved the problem!! Any idea...

Hi, I was wondering if any of you boys can help me. the oil level light has never worked since I bought the bike. On investigation I noticed that the wire coming from the oil level sensor isn't actually connected anywhere. I cant find any likely places for it to plug in. Can anyone shed any...

Hy, Rebuilding Royal Venture project Electrical harness from A to Z (doing the harness from zero) I`m trying to understand the way it works so, Testing oil level sender Oil level sender has no contact (open circuit) when float is down= low oil level Oil level sender has contact (close...

I found a fuel leak, and after cleaning things up tracked it down to the fuel level sensor. Interestingly, it's something the Haynes manual includes checking for every 4000 miles. Tried tweaking the screws tighter, which slowed the leak a little (already very slow) but a little paranoid about...

If anayone have the Vmax fuel sender mesurement this is my Venture fuel tank 1 5/16" center to center of the 6mm taped hole slut is 3/4" long X 3/8" wide dose the Vmax fuel sender would fit in there

Anyone know what the thread size is on the temp gauge sensor? I am guessing its M10 x 1.0. I need to figure out a way to install a M6 sensor in place of the original M10 sensor. I was looking for adaptors that go from M10 x 1.0 to M6 x 1.0 but don't see them anywhere. My next idea would...

Can the low fuel level sender thermistor assy. be removed fairly easily without removing a bunch of crap? Mine took a dump and I need to replace it. Thanx, Bud

Is it considered 1/8 or 3/8 th's ? What tread # ? TIA...

anyone know off the top of there heads what the part # is for the lower temp. fan switch is i have seen it here somewhere but cant find it again so i am taking the lazy way out and asking. i know there is one the fits with no mods except for maybe the wire ends and it was a common auto store...

OK, I'm installing a new temp gauge...... Can I use the stock sender or do I have to use the one that came from Autometer?