I am reinstalling the Barnette Clutch plates. I've put all the parts that I took off back on: One washer, one flat washer with tabs, one nut, one little ball bearing and the bolt looking thing that goes on last. Seems like there is room for more disks or do the clutch plates sit in the basket kinda loose? Here are a few pics.
The first pic shows the plates and there is a gap between the first plate and the cover.
The second pic I simply slid the plates over to show how much space is in there.
On the left side of the bike where the slave cylinder goes a little bit of the rod is sticking out. Should I be able to push that by hand? I can't get it to push, I can pull it out though. Any suggestions are appreciated. :confused2:
The first pic shows the plates and there is a gap between the first plate and the cover.
The second pic I simply slid the plates over to show how much space is in there.
On the left side of the bike where the slave cylinder goes a little bit of the rod is sticking out. Should I be able to push that by hand? I can't get it to push, I can pull it out though. Any suggestions are appreciated. :confused2: