tight

Hello, last year I Bought a 05 that had stage 7 installed. It had a crap idle off choke from sitting for a year so attempted shotgun clean. Cleaning went OK till I got to right rear carb and found the A/F screw missing. I Ordered a replacement and bike idled better so I rode it and was too...

Po installed exhaust system. Tightened the clamps enough that they slightly bent the pipes out-of-round. Real bitch to get apart and put back together. Any suggestions for how I can straighten them out at home without damaging the coating? Just a bit of a dent, barely noticeable when they are...

Unless, of course, we just open the doors and let 'em in! http://bostonherald.com/news_opinion/local_coverage/2014/09/three_afghan_soldiers_missing_from_cape_cod_base I'm pretty sure that guy who shot General Greene in the back was a 'trusted ally' too....posed no known threat....blah...

Hello everyone, just wandering if someone got this seat cover from france on ebay, got it yesterday and it look awsome, not exactly as show in the picture but better looking, the picture don't do it justice at all, anyway my question is do you have to remove the old leather on the seat to...

I have to get the front pulley off the motor to do the starter bolts. I bought one of those 3 bolt pullers, and broke it. The next one I bent the bolt. I've got a better one now. I still couldn't get it off. The last thing I did was heat the centre of the pulley up to about 330'C, 540'F. Then...

How to make your air box fit tight I had trouble with my air box ocassionally popping off one carb or the other making the bike run bad before I discovered it had popped of one of my carbs. I could actually pull the air box off with my hands after all four clamps were tightened. Upon futher...

Hi, took my front wheel off for the first time today(long story, another post) put it back on by the book, wheel spun freely w/o calipers, put on calipers and squeezed the lever a few times and now wheel barely turns due to pads contacting disc. Is this normal? Does it adjust when you ride...

Swapped forks recently. What is the torque spec for the front axle? Too tight and it puts stress on the wheel bearings and the wheel doesn't turn like it should. Too loose and I worry that it could work out because it doesn't have a lock bolt or clip.

Hey guys I went and did my pre-season maintenance.i went to change my oil and filter,When i tried to get the OEM filter off of my bike I had to use a pipe wrench to get it off and I mean just cranking on it hardcore!!!So I put the new one on which was a WIX it screwed on easy enough.I didn't buy...

Hey guys, just installed a K&N on a 04 vmax and when I went to close up the airbox, I was surprised to see that there was about a 3/16 gap all around the airbox lid. So I checked and double checked that there was'nt anything restricting the lid or the filter from sitting correctly. I had to...

I am going to tighten the chain on my wife's Fazer, but I have never tightened a chain before. So how tight should I get it? I know it is a simple question and I should know the answer but I need some advice Please....

Had the dealer change tires yeaterday on my 85 Vmax and everything was going well until we noticed the front wheel brake pads were "real tight" on the front caliper, as if the brake lever was already pulled to about 50%. Without pulling the calipers off, they tried to push the pistons back a...