Anyone have much experience with those cheapo B&G carbs on std push motors? I have two older mowers down cause the carbs are shot. My latest Sears mower is about to go hoots up. The thing dies at any point while mowing. I have to prime the thing, then it waivers, running up and down in rpms. When it starts speeding up and running smooth, it's getting ready to die out. I pump the primer, then it runs for a few minutes again. I got an over gskt kit. I did this with the other two mowers. It helped one for a while but not the other. I did find out, if ya use too much Sea Foam and do not run it through, completely out, that red rubber button melts.
Like I said, I have my 3rd mower going down. The motors are fine. Can I do anything to the carbs or are they just disposable? If I recall right, the carbs are close to a hundred a pop. If so, I can get a mower at the end of the season for that.
Am going out shortly to start working of the Sears mower carb. Will see how the kit works on it. I'm not holding my breath, for sure.
Like I said, I have my 3rd mower going down. The motors are fine. Can I do anything to the carbs or are they just disposable? If I recall right, the carbs are close to a hundred a pop. If so, I can get a mower at the end of the season for that.
Am going out shortly to start working of the Sears mower carb. Will see how the kit works on it. I'm not holding my breath, for sure.