Hey Folks,
I just wanted to drop in and say hi. I am glad to be a new site sponsor and hope to be spending a little time here as my schedule allows. I also wanted to post a few things I have been working on. First being the Jumper Harness. Here is a pic of the prototype:
I designed this to effectively make installing a PCV a plug and play process. In addition to the wires being labeled with the respective signal it carries, I have also included holes in the PCB for 12VDC, Ground, Digital Ground, Throttle Position Sensor, and the Speed signal. I have a few fine tweaks to make like sizing all the wire labels to the same size and I expect the enclosure to be here in a few days. This board was a introductory stepping stone for me to build upon. I plan to redesign this board in the future and integrate circuits into it effectively making them plug and play. I am currently considering circuits such as Speed Fooler - Error correction and Cruise Control. I am currently designing the board for the Top Fuel Faux Files that has everyones attention. I have completed writing the firmware and I am now looking at the analog LED circuits that will be mounted in each scoop.
Next, I pretty much have the ability to adjust all of the pertinent functions of the ECU. This has been a long and tedious process. I have been testing and adjusting a file for the prototype pipe made by Darren Crays. The file I have built has the ignition timing and YCC-T adjusted as well as each cylinder individually mapped to the performance characteristics of Darren's pipe. This has resulted in the highest horsepower and torque readings I have measured to date. I intend to bundle Darren's pipe and ECU flash into a KaHoot Kit. As time goes by, I will re-visit other systems and build a file for them as well.
Starting Friday, I will be traveling and I will have limited internet service if any at all. Forgive me if you do not get an immediate response from me.
Ride soon,
Tim Nash
GuruedGear.com
VMaxGuru.com
I just wanted to drop in and say hi. I am glad to be a new site sponsor and hope to be spending a little time here as my schedule allows. I also wanted to post a few things I have been working on. First being the Jumper Harness. Here is a pic of the prototype:
I designed this to effectively make installing a PCV a plug and play process. In addition to the wires being labeled with the respective signal it carries, I have also included holes in the PCB for 12VDC, Ground, Digital Ground, Throttle Position Sensor, and the Speed signal. I have a few fine tweaks to make like sizing all the wire labels to the same size and I expect the enclosure to be here in a few days. This board was a introductory stepping stone for me to build upon. I plan to redesign this board in the future and integrate circuits into it effectively making them plug and play. I am currently considering circuits such as Speed Fooler - Error correction and Cruise Control. I am currently designing the board for the Top Fuel Faux Files that has everyones attention. I have completed writing the firmware and I am now looking at the analog LED circuits that will be mounted in each scoop.
Next, I pretty much have the ability to adjust all of the pertinent functions of the ECU. This has been a long and tedious process. I have been testing and adjusting a file for the prototype pipe made by Darren Crays. The file I have built has the ignition timing and YCC-T adjusted as well as each cylinder individually mapped to the performance characteristics of Darren's pipe. This has resulted in the highest horsepower and torque readings I have measured to date. I intend to bundle Darren's pipe and ECU flash into a KaHoot Kit. As time goes by, I will re-visit other systems and build a file for them as well.
Starting Friday, I will be traveling and I will have limited internet service if any at all. Forgive me if you do not get an immediate response from me.
Ride soon,
Tim Nash
GuruedGear.com
VMaxGuru.com
Last edited: