vboost servo thing - install problem - with pic

[pipelinepete]

Hello,
I'm trying to reinstall the stock vboost system after removing an S7 kit; I want to put the bike back to OEM. Not having done this before I'm having a few challenges. My immediate problem is that I don't see an easy way to install the 2 screws that hold the servo/ motor thing in place (that's the device that pulls the cable). The rearward screw is easy enough to get at, but the forward screw is quite a challenge, sitting right in front of the coil. It looks to me like I'll have to remove a great deal of equipment to get at this screw. Am I doing this right? Comments appreciated. Thanks. Peter.

 

[one2dmax]

Looks right. The screws are accessible with a long screwdriver from the right hand side of the bike.

 

[pipelinepete]

Looks right. The screws are accessible with a long screwdriver from the right hand side of the bike.

Yes, that's right, dannymax also pointed this out.
Got the servo bolted up tight, now onto the rest of the job...thanks!
Peter