damage

Located in Bucyrus OH. Also available: 2015 Jeep Grand Cherokee, same condition, same location. http://crawfordcountynow.com/local/police-searching-for-box-truck-involved-in-crash/

Looking at getting a V Star 1300 and, according to the seller, the guy before him had a very low speed tip over. The front fender is crooked, the handlebar dented the tank, and some other stuff got the usual scrapes. Supposedly the current owner bought it from him and hasn't had an issue in the...

Ok. Some of you might remember that my fan did not come on during my trip this summer, and I spewed coolant all over everything for about 10 seconds before I could get out of traffic to the side of the road. I went to a gas station after it cooled down a bit, topped off the coolant and fixed...

OK, here's what's been done so far. Changed entire wiring harness as the original burned and fused together near the fuel pump. Had to replace pump relay before new pump would run. After that It started instantly, but no ignition to the rear cylinders. Also, vboost doesn't cycle...

Reposted from electrical for maybe more views: Hi all, I have just replaced the entire wiring harness on my Vmax after my old one nearly burned in two in the fuel pump area from a fuel fire. Haven't pinpointed the cause yet, but I did discover that tank vent valve was clogged. I did find a...

Hi all, I have just replaced the entire wiring harness on my Vmax after my old one nearly burned in two in the fuel pump area from a fuel fire. Haven't pinpointed the cause yet, but I did discover that tank vent valve was clogged. I did find a lot of cracks in the fuel pump diaphram, and the...

Hello, I was adjusting the pilots crews for VMax, today I found that one of the screw was missing from carburetor, what kind of damage can this cause? If pilot screw is missing is it running lean or rich? /Jonas

I was looking for what sounded like a loose tappet. None of the clearances were loose. Most of them were too tight. I've set the clearances now, but when I was doing it I noticed that 2 of the buckets wouldn't turn. I pulled them out to try and free them up, and found slight damage in the...

EVERYONE , CHECK THIS OUT ! .. AWESOME ! .. :punk:CLICK ON , HOW IT WORKS & THEN SCROLL ALL THE WAY DOWN & CLICK ON PLAY ! .. http://www.thermahelm.com/

So, a guy my wife works with got back from his ride to/from Sturgis, and now has problems with two fingers on his throttle hand. Nerve and vascular damage. Ack. Fingers are discolored and have no feeling. He's getting it treated, but Jesus. My wife, bless her soul, immediately made fun of...

Will be a nice buy it it stays around this price. I hope it is not the one from VA where the couple passed away. The damage looks too light to be a killer, more like a wheelie gone bad. http://www.salvagedirect.com/asp/viewitem.asp?itemid=721085

If you are getting a 09 vmax check the front fender for scratches and maring. It is prone to getting scratched and or mared due to the way it is packaged for shipping. It can be easily damaged if blade is used to open box.

well i got my cousin's max to my garage tonight and just had to tear into it . i first thought the swing arm was racked but when i removed it it looks strait but the gas tank had the right side cover popped out some. so i go deeper strip the whole ass end including the tank and it gave me a hard...

while the max was parked at the local mall a while back someone tried to jimmy the ignition key. by doing so they damaged the opening there is no flap covering the hole once the key is removed.....i am sure this will pose a problem with water getting into the switch and corroding contacts...

Long story short, my father just received this forks in the mail for me. I bought and paid for them on eBay/Paypal. I'm in Bolivia for three more weeks, and he hasn't opened the package, he just recieved it and noted the damage, and my sister photographed them for me. Should I accept this as...