bro.betterley
Well-Known Member
I suspect that one of my carbs are leaking into one of my cylinder when it sits
Symtoms
1.when i pull the plug in one cylinder its wet even after sitting a day
2.my gas millage is poor only getting about 85-90 miles before light comes on
3. the fuel pump pumps really long after just sitting a few minutes between start up like when getting gas.
OTHER FACTS
1. The floats are set to 17 wet, even in the suspected cylinder
2. The compression in all cylinders is within 5 pounds around 160psi (my gauge is always low)
3. Plugs read on the lean side a light grey
So is this possible,can a carb leak into cylinder even if the float is adjusted right?
Symtoms
1.when i pull the plug in one cylinder its wet even after sitting a day
2.my gas millage is poor only getting about 85-90 miles before light comes on
3. the fuel pump pumps really long after just sitting a few minutes between start up like when getting gas.
OTHER FACTS
1. The floats are set to 17 wet, even in the suspected cylinder
2. The compression in all cylinders is within 5 pounds around 160psi (my gauge is always low)
3. Plugs read on the lean side a light grey
So is this possible,can a carb leak into cylinder even if the float is adjusted right?