Morley airbox pics

[Sharky]

Does anyone have any pics of the inside ?
I'm going to get the kit but as I am going to be fitting a 2/3 scale Scott charger hat and base I would like to see if there is room for it.
cheers fells

 

[one2dmax]

Nothing modified on the lower half of the box. The filter I don't think protrudes below the "plane" of the top lid (at least not much).

 

[KJShover]

 

[Sharky]

Cheers mate.
Decided to go with the stock style K&N filter as it suits the intake

 

[vmaxinID]

Nothing near the pull you'd have with a Morley conversion. FYI.

 

[Redbone]

Nothing near the pull you'd have with a Morley conversion. FYI.

COOL, you DO get internets way out thar in the evergreen state!

 

[davesax36]

Nothing near the pull you'd have with a Morley conversion. FYI.

What about with stock pipes...?

Sent from my Galaxy Nexus using Tapatalk 2

 

[Redbone]

What about with stock pipes...?

Sent from my Galaxy Nexus using Tapatalk 2

You need to have a aftermarket exhaust before you can start pumping a larger load of fuel/ air through the carbs. The stock pipes are too small to flow enough to work. You can jet a stock carb to work well with aftermarket exhaust and gain a little power.

 

[davesax36]

That's what I thought.

Sent from my Galaxy Nexus using Tapatalk 2

 

[Sharky]

Bit of an old thread revival but as I have scored a kerker 4-2-1 I figured I should do it service and fit morleys kit.
I'll have to get creative to make it fit as the stock air box has been trimmed to fit under my new air box cover.
I'm thinking a carbon fibre box made to fit properly would suit...I'm not using the Mad Max style scoop anymore.
Found some pics an realized the filter is fitted on the top of the upper piece.
I'll have to start from scratch.........