Harley front end,stem dimensions

[jedi-]

Here is a picture with the machining dimensions required to make an Ultima Inverted Harley type front end fit the Max.
The stem supplied with the front end needs to be re machined as follows in the pic.

 

[maxcruiser]

Thanks for the info, Jedi!

As you previously stated, pretty straight forward mod to get the harley inverted installed on the max.

Once again, YOU THE MAN!!!

Mike

 

[rarick123]

What about axle size on the Ultima forks? Can you still use the stock wheels? Do you lose the speedo?

 

[[email protected]]

Jedi used HD wheels

 

[one2dmax]

Getting ready to do a kit on a local bike. At work and can't remember the fork length? Anyone at home (or with a bike at work) that can go measure the axle to end of tube length? Also, wonder what the upper bearing number was with the seal on it?

Sean

 

[Mitchell]

Getting ready to do a kit on a local bike. At work and can't remember the fork length? Anyone at home (or with a bike at work) that can go measure the axle to end of tube length? Also, wonder what the upper bearing number was with the seal on it?

Sean

Sean, I can measure it for for you. Do you mean the full length of the forks? Or from the axle to the top of the lower slider:confused2:

 

[one2dmax]

Axle to the top of the triple (or if the fork sticks past the top of the tube).

Sean

 

[eatatjoz]

center of axle to top of the forks looked like 32 3/4".

 

[one2dmax]

Thank you!