zippo6
Well-Known Member
Ok, so I'm working my way through shotgun'ing my carbs, I'm only to the point where I seat the mixture screws, then back them out.
Here's my problem, I started with cylinder 4? (right side rear), seated the screw, noting the number of turns, then began to back it out. It came out about 2 turns then began to stiffen and there was resistance. I turned it back in and then back out, same thing. So I stopped. Moved to cylinder 3?(right front). It won't move at all.
Suggestions? Do I just force them out? :ummm:
Here's my problem, I started with cylinder 4? (right side rear), seated the screw, noting the number of turns, then began to back it out. It came out about 2 turns then began to stiffen and there was resistance. I turned it back in and then back out, same thing. So I stopped. Moved to cylinder 3?(right front). It won't move at all.
Suggestions? Do I just force them out? :ummm: