low

So my question has to do with what the bike is looking for to achieve more low end torque. From the stock bike you can add stage seven and that tends to give you more top end power, you can go to morleys setup and get more even power throughout. Now what is it that makes more low end torque? Are...

a little back ground. I have an 05 vmax roughly 30k miles. a couple years ago I did the cops mod and all has been well. well I have a nerve issue that will cause loss of strength on my leg ( totally random when it does it) anyway it happened the other day when backing the bike out of a friends...

Hi from Norway! My completely stock '99 1200 145hp V-max has developed a stutter,especially when warm. I cant feel this when the engine is cold. When I cruise on low revs the engine stutters and makes it very uncomfortable to ride. When I run on high revolutions I can't notice the problem. When...

Topic: I have read more than a few posts now about the temperature problems with the VMAX. It was one of the first things that brought me to this forum after purchasing my Mr. Max this year, seeing it for myself, then searching for a solution. On this forum there is a split for those who...

just started running on 2 cylinders when at idle, and tach goes dead. I twist the throttle ever so slightly, and I can feel when all 4 cylinders start firing at about 1150 rpm, and the tach simultaneously jumps to life. very hard to start now, if it'll start at all. when I do get it to start, I...

I'm experiencing no spark on cylinder #1 at low revs on my '86 - on idle that cylinder stays cold, when riding I can hear and feel it kick in at around 4500-5000rpm. :ummm: I have thrown new plugs in, and I have replaced the coil. I've measured tension on the coil connector and both wires show...

Seems like that low rpm idle problem is popping up alot in this now hot weather. I feel fairly sure that the problem on mine is the wires. Upon inspection, the wires were very badly corroded where they plug into the coils, and I was missing one of the grommets that hold the plug wire to the...

Hey all, OK I can't seem to get a rolling burnout on my max. I've lost the rear a bit once before, and maybe have done it once but i can't consistently shred rubber. I let go the clutch, and maybe am going about 5mph, and then hammer the throttle...it goes pretty good but no burnout...

I tried a little experiment about a year ago and didn’t want to post anything until I could get Dyno #s to go along with the idea. I have Dale Walker Holeshot exhaust. I originally took off the slip on mufflers and replaced them with Hedman Hot Tips 17120 exhaust tips. (about $25 each)...

I had a low speed drop a couple days ago and since my steering feels light. My riding skills are alway improving and im able to put her where I want to go more and more but since the drop, the steering feels "very light". Like the slightest touch will turn the bars. This occurs at all speeds...

Hey guys- On average I get 130km or 80 Miles till my light comes on. First off, it's warming up in Canada finally and I'm using the choke less and less. Basically, I keep Adjusting the choke lower and lower till I reach my idle. I've kept it choked for quite a while when it's -5 C or 23 F...

I have this problem which I needs all of Vmaxers' advise.. 1) starts engine. Engine is running well at approx 1k rpm..warming up well too.. 2) ride off slow in multi-storey car park.. Ride at approx 10-15km/hr... Bike starts to cough and jerk. Clutch in, engine stop. Restart again.. Engine...

I was driving my bike one day and out of nowhere smoke comes up from the regulator and the main fuse blows. I removed the old one and replaced it with a new. I am only getting 1.2 volts from the new could the stator be bad even though its getting 30-50 volts ac and 42 ohms out of it. So confused...

Hi i've been looking thru this site looking at gettin some info on why my friends max is running so poor and have a question, I see some of you run with the boost valve fully open all the time, does this not cause overrichness at lower speeds ? or do you down jet on the pilot circuits to...

Hey guys, I've been enjoying my Vmax for the past 5 months until the gearbox broke down and I had to park it for a while until I got it fixed. Now my problem is, and this has been going on since I bought it, it runs a very low mile per gallon, and by low I mean from full tank to fuel light...

http://newyork.cbslocal.com/2012/03/19/bloomberg-strikes-again-nyc-bans-food-donations-to-the-homeless/ I just want to know how you become a billionaire when you don't have the common sense of a flea.

I noticed last week that my 2001 was dropping the front left cylinder at low RPMs. At idle I don't think it's firing at all. When revving the bike in neutral I can hear the bike spit and pop ever so slightly in the 3k to 4k range and think the cylinder finally picks up consistently around 4k...

i have low vac on #1 carb snyc the left side got to the right side and #1 carb has low vac i have turned both adjustment screws on the right side and the back carb on the right side vac moves i need help[ its a2003 i got in feb 2012 so im new

Hey guys where can I get a 1 inch spanner wrench to adjust my head bearings ? .I have some wobble.

Hi. i have a 96 vmax with 7,000 miles, new Dunlop tires. The bike handles great except from time to time at speeds under 25mph the bike will wiggle from side to side like you just cant hold it in a straight line. anyone have any suggestions? otherwise its a great bike.