customizedcreationz
Well-Known Member
Well I wanted to show this off at the track tomorrow. But doesn't look like its going to happen.
This is the rough prototype, have a few changes to make. But it bolts on and goes now, just cosmetically and in the program I have to alter a few things to make it easier and faster to machine.
Step one.... a block of 6061 aluminum.....
Step two.... machining the back side...
Step three......Machining the front side.....
Step four...... the embossed and in the white finished product basically.....
I am going to debur it and clean it up a little, powder coat it glossy black to match the engine and then brush finish the letters like I do my skull badges.
I have a skull one I am doing next to match the cylinder covers I make.
I have a few more things coming along soon as well....
Thanks
Todd
This is the rough prototype, have a few changes to make. But it bolts on and goes now, just cosmetically and in the program I have to alter a few things to make it easier and faster to machine.
Step one.... a block of 6061 aluminum.....
Step two.... machining the back side...
Step three......Machining the front side.....
Step four...... the embossed and in the white finished product basically.....
I am going to debur it and clean it up a little, powder coat it glossy black to match the engine and then brush finish the letters like I do my skull badges.
I have a skull one I am doing next to match the cylinder covers I make.
I have a few more things coming along soon as well....
Thanks
Todd