I adjusted the float height on my '06 last summer - was way too high - using the bench method and measuring on the inside of the housing, but I'd like to check the actual fuel level. I tried to do this with the carbs on the bike but had no luck getting a consistent measurement.
So, how do you guys do it? Does a gravity feed fuel supply make enough pressure to produce an accurate reading? Also, what do you use to measure? I'm assuming a clear plastic tube with some gradations marked on it to compare against the marker on the side of the carb?
Thanks in advance.
So, how do you guys do it? Does a gravity feed fuel supply make enough pressure to produce an accurate reading? Also, what do you use to measure? I'm assuming a clear plastic tube with some gradations marked on it to compare against the marker on the side of the carb?
Thanks in advance.