yukonerdave
Well-Known Member
Hello
After the better part of a day I finally got the upper bearing races removed. The lower races, however, look even more stubborn. There is no lip at all to drive it out with a long screwdriver from above. One suggestion was to weld a bead directly onto it and use that to drive it out. I haven't got a welder, nor do I know anyone around with one. Any other suggestions? I suppose I could try to cut it with a dremel, but I'd prefer something with less risk of screwing something up if it would work.
Thanks!
After the better part of a day I finally got the upper bearing races removed. The lower races, however, look even more stubborn. There is no lip at all to drive it out with a long screwdriver from above. One suggestion was to weld a bead directly onto it and use that to drive it out. I haven't got a welder, nor do I know anyone around with one. Any other suggestions? I suppose I could try to cut it with a dremel, but I'd prefer something with less risk of screwing something up if it would work.
Thanks!